德国UTP UP 6222 Mo焊丝UTP UP 6222 Mo UTP UP FX 6222 Mo SAW Wire Classifications high-alloyed EN ISO 18274: AWS A5.14: S Ni 6625 (NiCr22Mo9Nb) ERNiCrMo-3 Characteristics and field of use UTP UP 6222 Mo and the flux UTP UP FX 6222 Mo are applied for joint welding of base materials with the same or with a similar comb, e. g. Alloy 625 (UNS N06625) or NiCr22Mo9Nb, Material-No. 2.4856 or mixed combinations with stainless steels and carbon steels. Furthermore the wire-flux combination is used for cold-tough Ni-steels, e. g. X8Ni9 for LNG projects. UTP UP 6222 Mo / UTP UP FX 6222 Mo is also applied0n alloyed or unalloyed steels for cladding of corrosion resistant plants. Base materials 2.4856 NiCr22Mo9Nb, 2.4858 NiCr21Mo, 2.4816 NiCr15Fe, 1.4583 X10CrNiMoNb18-12, 1.4876 X10NiCrAlTi32-21, 1.4529 X1NiCrMoCuN25-20-7, X2CrNiMoCuN20-18-6, 2.4641 NiCr21Mo6Cu- Dissimilar joints of the steels above with unalloyed and low alloyed steels like P265GH, P285NH, P295GH, 16Mo3, S355N, X8Ni9, ASTM A 553 Gr.1, B443, B446, UNS N06625 N 08926, Alloy 600, Alloy 625, Alloy 800, steels with 9% Ni Typical analysis of all-weld bl (Wt-%) C Si Cr Mo Ni Nb Fe < 0.02 < 0.2 21.0 9.0 balance 3.3 2.0 Mechanical properties of all-weld bl Heat Treatment Yield strength 0.2% Tensile strength Elongation (L0=5d0) Impact values in J CVN MPa MPa % +20°C: -196°C: untreated 460 725 40 > 80 65 Operating data Polarity = ± The welding area has to be free from impurities (oil, paint, markings etc.). Welding must be perbed with a low heat bbbbb. The maximum interpass temperature is at 150° C. Flux has to be re-dried prior to welding: 2 hours at 300 - 400° C. Flux height: approx. 25 mm Stick out: approx. 25 mm Dimensions (mm) 1.6 2.0 2.4 3.2 Approvals and certificates TüV (03918.)
