Y6手提式凿岩机使用说明书
Operation instruction of Y6 portable rock drilling
Y6手提式凿岩机 Y6 portable rock drilling
重量 weight (kg)
全长 length (mm)
工作气压 working pressure 0.4-0.63Mpa
气管内径inner diameter of the gas pipe(mm)
耗气量 gas consumption(L/s) ≤
凿岩频率 Drilling frequency(Hz) ≥51HZ
钎头直径 diameter of drill bit (mm)
Y6手持式凿岩机使用与维护
Operation and maintenance of Y6 portable rock drilling
1、连接通气管前必须先将管道内吹洗干净，以防杂物堵塞通道。
Before getting through the pipe, it should be cleaned up inside the pipe to prevent channel from jamming by sundries.
2、开机前检查气管接头是否拧紧，以免气管崩脱伤人。
Before turn on the machine, the jointer of the gas pipe should be checked to be fastening, to avoid damage.
3、工作时应注意润滑油，推荐使用GB443规定的N46、N22的润滑油。
During operating, the lubricating oil should be took care. N46,N22 of lubricating oil ordered by GB443 is supposed to be used.
4、钎尾规格本机推荐B25-28-4钎焊或YZT2017-2.8的整体钎杆。
Shank size of this machine was suggested to use B25-28-4 brazing or YZT2017-2.8 of whole drill rod.
5、常用机器应注意定期保养，如长期停止使用，应拆卸清洗，油封保存，置于干燥处。
It should be maintenance in a certain time when the machine is in common use. If it will be stopped for a long time, it should be disassembled and cleaned, covering with oil and put into the dry place for stock.
