ABB避雷器放电记录仪DJS-II(标称放电电流5KA残压1KV）DJS-I（220V)

　　LOVOS避雷器频率范围覆盖48到62赫兹，适用于户内及户外应用。标称放电电流为5 kA或10 kA。连续工作电压Uc为280 V,V, 500 V或660 V。

　　LOVOS低压避雷器可用于以下保护：

　　低压架空线路

　　独立电能接收器

　　配电变压器

　　其他可受雷电和开关操作影响的电气设备

　　为何选择ABB-

　　与全球客户密切合作并设计

　　满足全球及本地市场需求

　　高质量，高可靠性

　　DJs Baidu series high sensitive arrester discharge recorder function introduction DJs series high sensitive arrester discharge recorder (hereinafter referred to as DJs) is an electronic arrester discharge counter for indoor use (optional arrester leakage current on-line monitoring). It is suitable for discharge counting of arresters without (with Series) gap below 35KV. It can record a, B and C. the number of discharge bs and corresponding discharge time of lightning arrester, liquid crystal display, data recording volume of more than 1000 times, strong anti-interference ability and high sensitivity, and provide network communication and data download interface. Product features: three-phase centralized counting, strip recording of discharge time, communicable, electronic liquid crystal display. Working principle and product comb DJs series high sensitive lightning arrester discharge recorder is mainly composed of sampler, sensor, adapter box, display, supporting transmission cable and some electronic components. Under normal operating voltage, the change of leakage current through lightning arrester is transmitted to the display through sampler and relevant cables, and converted into digital signal and displayed under the control of microprocessor in the display through amplification circuit and a / D conversion circuit in the display. When the lightning arrester flows through lightning wave, operation wave or power frequency overvoltage, the strong b current will be transferred from the leakage current measurement circuit to the counter circuit, and the leakage current measurement circuit is protected. The counter part uses the principle of electromagnetic induction to obtain the signal of operation wave or power frequency overvoltage current, and then processed by the microprocessor in the display to record the number of bs

　　DJs百度系列高灵敏避雷器放电记录仪功能简介DJs系列高灵敏避雷器放电记录仪（以下简称DJs）是一种用于室内使用的电子式避雷器放电计数器（可选避雷器泄漏电流在线监测）。适用于35KV以下无（串联）间隙避雷器的放电计数。可记录避雷器a、B、C放电动作次数及相应放电时间，液晶显示，数据记录量1000次以上，抗干扰能力强，灵敏度高，并提供网络通信和数据下载接口。产品特点：三相集中计数，放电时间条形记录，通讯，电子液晶显示。DJs系列高灵敏避雷器放电记录仪的工作原理及产品组成主要由采样器、传感器、转接盒、显示器、配套传输电缆及部分电子元器件组成。在正常工作电压下，通过避雷器的泄漏电流变化通过采样器及相关电缆传输至显示器，并通过显示器中的放大电路和a/D转换电路转换为数字信号，在显示器中的微处理器控制下显示。当避雷器流过雷击波、工作波或工频过电压时，强动作电流从泄漏电流测量电路传输到反电路，泄漏电流测量电路受到保护。计数器部分利用电磁感应原理获取工作波或工频过电压电流信号，然后在显示器上经微处理器处理，记录动作次数

　　1. Scope of application: 3 ~ 35kV system discrete lightning arrester without (with Series) gap; 2. Power supply: AC / DC 110 ~ 220V, ＜ 1.5W;

　　3. Counting b: A, B and C phases are counted separaby and displayed on centralized LCD; 4. Minimum capture discharge current: ＜ 10A; 5. Minimum capture pulse b: ＜ 1 μ s； 6. Leakage current monitoring range: 0 ~ 20mA; 7. Built in clock, power failure holding time: half a year; 8. Storage capacity: ＞ 2000 pieces;

　　9. Communication interface: 485, class Modbus protocol; 10. Independent address code can be set

　　Method of use

　　1. Connect the corresponding wiring according to the operation manual;

　　2. When powered on, the LCD is displayed in turn according to the sequence of phase a counting, phase B counting and phase C counting;

　　3. Short touch the "F" key to check phase a count, phase B count, phase C count, local address, current date and current address in turn

　　Time, when the current time is displayed, if it is djs-ii type, press the "F" key three times to zero the leakage current value (please pull out the data cable during zero calibration).

　　4. Long press the "F" key, then "CLR" will b whether all counts are bed, and "-" will be displayed. After a "-" appears

　　Execute the reset operation, and release the "F" key to exit before a "-" appears; 5. After pressing "▲" and "▼" at the same time to enter the setting state, the "year" bit flashes first, which can be adjusted by up and down keys; adopt

　　Short touch "F" to switch to "month", "day", "hour", "minute" and "second" in sequence. When the second adjustment is over, short touch "F" to display the address code of the counter. If adjustment is needed, press "▲" and "▼" to adjust, and the adjustment will take effect immediaby; During the adjustment, if the operation stops at any b for more than 7S, the standby state will be restored automatically, and the previous adjustment is effective. 6. Relevant data can be managed by background software through 485 bus;

　　7. Data can be downloaded and analyzed with special software through mobile computer and 485-232 transfer interface.

　　Overall dimension, installation b and wiring diagram

　　Overall dimension

　　1.适用范围：3~35kV系统无（带串联）间隙离散型避雷器；2.电源：交流/直流110~220V，＜1.5W；

　　3.计数形式：A、B、C相分别计数，集中液晶显示；4.最小捕获放电电流：＜10A；5.最小捕获脉冲宽度：＜1μs；6。泄漏电流监测范围：0~20mA；7.内置时钟，断电保持时间：半年；8.存储容量：＞2000件；

　　9通讯接口：485，Modbus类协议；10可以设置独立的地址代码

　　使用方