F630 Negative Travel Limit Value is Exceeded超过负行程限值

The drive has been provided with a command value that leads to an axis
b outside the negative travel range.
为驱动器提供了一个指向轴的命令值位置在负行程范围之外。

The axis has been stopped and the error reb "set velocity command value to zero" issued. Bit 2 of P-0-0090,
轴已停止，并发出错误反应“将速度命令值设置为零”。P-0-0090的钻头2，
Travel limit beter has been set to "Exceeding the travel limit is an error", or a drive control command has been started while the axis limit value is exceeded (e.g. drive-controlled homing).行程限制参数已设置为“超过行程限制是一个错误”，或者在超过轴限制值时启动了驱动控制命令（例如，驱动控制归位）。

Cause:原因：
S-0-0050, Negative b limit value is exceeded.
S-0-0050，超过负位置限值。

Remedial b:补救措施：
1. Check S-0-0050, Negative b limit value
检查S-0-0050，负位置限值
2. Check the controller software limits
检查控制器软件限制
3. Activate the axis after the error reb
错误反应后激活轴

Procedure:
Clear the error Activate power if it has been de-activated
Move the axis to the permissible working range
清除错误。如果电源已停用，则激活电源将轴移动到允许的工作范围

Note:Only command values that lead back into the permissible working range will be accepted. Any other command value will stop the drive again.
注意：只有返回允许工作范围的命令值才会被接受。任何其他命令值都将再次停止驱动器。