鄂尔多斯止水钢板400*3多少钱一米-工控行业信息网(chinagkong.com)-工控行业门户网站

产品简介

鄂尔多斯止水钢板400*3多少钱一米

产品价格：￥

上架日期：2017-09-26 09:06:55

产地：衡水

发货地：衡水

供应数量：不限

最少起订：1米

浏览量：113

点击询价 QQ洽谈

资料下载：暂无资料下载

其他下载：暂无相关下载

详细说明

鄂尔多斯止水钢板400*3多少钱一米

钢板止水带用途：

Application of steel sealing strip:
在箱型基础或地下室，底板和外墙板的混凝土是分开浇捣的，下次再浇捣墙板混凝土时，就有一条施工缝，当这条缝的位置在地下水位线以下时，就容易产生渗水。这样就需要对这条缝进行技术处理。处理的方法很多，其中比较通行的方法是设置钢边止水带。
In the box foundation or basement floor and wall panels are separated from the concrete pouring, pouring concrete wall again, there is a construction joint, when the crack b below the underground water level, it is easy to produce water. This requires a technical treatment of the seam. There are many ways to deal with it. The most popular way is to set up steel stop pipe.

即在浇筑下层混凝土时，预埋300*3的钢板，其中有10-15cm的上部露在外面，在下次再浇筑混凝土时把这部分的钢板一起浇筑进去，起到阻止外面的压力水渗入的作用。钢板止水带选择的厚度一般为2mm厚 3mm厚。一般钢板止水带是采用冷轧板作为母材，因为冷板厚度能够均匀，热板一般厚度达不到均匀的程度，厚度一般为2毫米或者3毫米，长度一般加工成3米长或者6米长，一般为三米好运输。钢边止水带对焊接节点要求较高，不能出现漏点，影响防水性能。

鄂尔多斯止水钢板400*3多少钱一米

In the lower concrete pouring, pre buried steel plate of 300*3, including the upper portion of the 10-15cm exposed, this part of the steel pouring in together again during the pouring of concrete, to prevent the outside pressure of water infiltration effect. The thickness of the steel sealing strip is usually 2mm thick and 3mm thick. General plate sealing strip is made of cold rolled plate as a base material for cold plate thickness can be generally unib, hot plate thickness is not up to the unib degree of thickness is 2 mm or 3 mm in length, generally processed into 3 meters long or 6 meters long, three meters generally good transportation. The steel edge sealing strip requires higher welding nodes, and no leakage point can be found, which affects the waterproof perbance.
施工要点：
Construction points:
1、应尽力保证钢边止水带在墙体中线上；
1, should try to ensure that the steel side of the water retaining wall in the middle of the wall;
2、两块钢板之间的焊接要饱满确保不渗水，一般是双面焊。根据监理要求，也可以单面焊接；
2, two pieces of steel between the welding should be full, to ensure that no water seepage, generally double-sided welding. According to the supervision requirements, can also be single-sided welding;
3、墙体转角处的处理，一、整块钢板弯折；二、丁字型焊接；三、7字型焊接。
3, the wall corner processing, one, the whole plate bending; two, T-shaped welding; three, 7 type welding.
4、钢边止水带的支撑焊接，可以用小钢筋电焊在主筋上；

4. The supporting welding of the steel stop belt can be welded with small steel bars on the main reinforcement;

鄂尔多斯止水钢板400*3多少钱一米

5、钢边止水带穿过柱箍筋时，可以将所穿过的箍筋断开，制作成开口箍，电焊在钢板上。
5. When the steel stop belt passes through the column hoop, the hoop hoop which is worn can be broken off and made into an opening hoop, and the electric welding is arranged on the steel plate.
钢板止水带即在浇筑下层混凝土时，预埋300mmx3mm的钢板，其中有10-15cm的上部露在外面，在下次再浇筑混凝土时把这部分的钢板一起浇筑进去，起到阻止外面的压力水渗入的作用。一般钢板止水带是采用冷轧板作为母材，因为冷板厚度能够均匀，热板一般厚度达不到均匀的程度，厚度一般为2毫米或者3毫米，长度一般加工成3米长或者6米长，一般为三米好运输。止水钢板对焊接节点要求较高，
In the plate strip pouring bottom concrete, pre buried steel plate of 300mmx3mm, including the upper portion of the 10-15cm exposed, this part of the steel pouring in together again during the pouring of concrete, to prevent the outside pressure of water infiltration effect. General plate sealing strip is made of cold rolled plate as a base material for cold plate thickness can be generally unib, hot plate thickness is not up to the unib degree of thickness is 2 mm or 3 mm in length, generally processed into 3 meters long or 6 meters long, three meters generally good transportation. The water stopping steel plate requires higher welding nodes,
止水钢板焊接节点
Welded joint of water stopping steel plate
止水钢板焊接节点
Welded joint of water stopping steel plate
不能出现漏点，影响防水性能。
Leakage can not occur, affecting waterproof perbance.
施工要点
Construction points
1、应尽力保证止水钢板在墙体中线上；
1, should try to ensure that the steel plate in the wall of the center line;
2、两块钢板之间的焊接要饱满且为双面焊，钢板搭接不小于20mm；
The welding between the 2 and two steel plates should be full and double sided welding, and the steel plate shall be lapped not less than 20mm;
3、墙体转角处的处理，一、整块钢板弯折；二、丁字型焊接；三、7字型焊接。
3, the wall corner processing, one, the whole plate bending; two, T-shaped welding; three, 7 type welding.
4、止水钢板的支撑焊接，可以用小钢筋电焊在主筋上；
4 、 the support welding of water stopping steel plate can be welded with small steel bars on the main reinforcement;
5、止水钢板穿过柱箍筋时，可以将所穿过的箍筋断开，制作成开口箍，电焊在钢板上。
5. When the water stopping steel plate passes through the column hoop, the hoop hoop which is crossed can be broken and made into an opening hoop, and the electric welding is arranged on the steel plate.
6、止水钢板的“开口”朝迎水面。

6. The opening of the water stop steel plate faces the water surface.

鄂尔多斯止水钢板400*3多少钱一米

在线询盘/留言

*您的姓名：

*联系手机：

固定电话：

*联系邮箱：

所在单位：

*需求数量：

*咨询内容：

您要求给厂家提供：

免责声明：以上所展示的信息由企业自行提供，内容的真实性、准确性和合法性由发布企业负责，本网对此不承担任何保证责任。我们原则上建议您选择本网高级会员或VIP会员。

企业信息

河北瑞博橡塑制品有限公司

会员级别：

------------ 联系方式 ------------

联系人：王伟（先生）

联系电话：0318-2110875

联系手机：13166570832

传真号码：0318-2110875

企业邮箱：3407742055@QQ.COM

网址：hsribo.jdzj.com

邮编：53500

企业网站

进入商铺